69A Commer 30 CWT Van 'Nestles' Decal Set

$4.10

69A Commer 30 CWT Van 'Nestles' Screen Printed Waterslide Decal Set - No Trimming Required
This is an original style decal that was screen printed, no trimming is needed once decal is loose on backing. See below.
Application: - Soak in clean water 30-60 seconds or until loose on backing, but not so long that it floats off of the backing on on its own. To make positioning easier pre-wet the surface your decal is going on, remove decal from water still on backing, slide one edge off of backing and onto model, gently hold decal in place on model and carefully pull backing away laying the decal down as you go. Position decal carefully, then using a soft paper towel or tissue, start at middle of decal and work out one direction smoothing air bubbles and water as you go and sopping up excess water, then do other side. Now the hard part, leave it alone! Let the decal dry before handling, 24 hours is best.
ToyResto.com Application Tip: - You may have a hard time chasing around the smaller decals once loose in a bowl of water. With the smaller decals just hold the decal gently between your thumb and forefinger with the front of the decal facing your forefinger and dip the whole thing in water, thumb, finger and decal, and hold. Once loose on backing slide away from backing by gently rubbing your thumb and forefinger together, keeping the front of the decal stuck to your forefinger and place on model, the decal will tend to stick to the flat surface of your model more so than your fingertip.

Sold Out
  • Model: 04-69ANE
  • Shipping Weight: 0.01lbs
  • 0 Units in Stock
  • Manufactured by: Matchbox



This product was added to our catalog on Wednesday 22 February, 2012.

Your IP Address is: 54.167.44.32
Copyright © 2017 ToyResto.com. Powered by ZiaCart