66C Greyhound Bus Silk Screened Waterslide Decal Pair


NEW DECAL 66C Greyhound Bus - Silk Screened Waterslide Decal Set - No Trimming Required
This is an original style decal that was silk screened, no trimming is needed once decal is loose on backing. See below.
Application: - Soak in clean water 30-60 seconds or until loose on backing, but not so long that it floats off of the backing on on its own. To make positioning easier pre-wet the surface your decal is going on, remove decal from water still on backing, slide one edge off of backing and onto model, gently hold decal in place on model and carefully pull backing away laying the decal down as you go. Position decal carefully, then using a soft paper towel or tissue, start at middle of decal and work out one direction smoothing air bubbles and water as you go and sopping up excess water, then do other side. Now the hard part, leave it alone! Let the decal dry before handling, 24 hours is best.
ToyResto.com Application Tip: - You may have a hard time chasing around the smaller decals once loose in a bowl of water. With the smaller decals just hold the decal gently between your thumb and forefinger with the front of the decal facing your forefinger and dip the whole thing in water, thumb, finger and decal, and hold. Once loose on backing lay leading edge on model and slide decal onto model, hold the edge on the model and slow pull away the backing laying the decal down as you go. Remember doing decals from your modeling days as a kid? Well this is like that except your fingers are a whole lot bigger and the decals are a whole lot smaller, so be careful.

Add to Cart:

  • Model: 04-66CBUS-P
  • 25 Units in Stock

This product was added to our catalog on Thursday 21 December, 2017.

Your IP Address is:
Copyright © 2018 ToyResto.com. Powered by ZiaCart