M10 Dinkum Dumper 'Whitlock D-D70' Waterslide Decal Set

$2.58

M10 Dinkum Dumper 'Whitlock D-D70' Waterslide Decal Set
Application - Soak in clean water 30-60 seconds or until loose on backing, but no so long that they float off of the backing on their own. To make positioning easier, pre-wet the surface your decal is going on, remove decal from water still on backing, slide one edge off of backing and onto model, gently hold decal in place and carefully pull backing away laying the decal down as you go. Position decal carefully, then using a soft paper towel or tissue, start at middle of decal and work out one direction smoothing air bubbles as you go and sopping up excess water, then do other side. Now the hard part, leave it alone! Let the decal dry before handling, 24 hours is best.

Add to Cart:

  • Model: 17-M10DD
  • Shipping Weight: 0.01lbs
  • 13 Units in Stock
  • Manufactured by: Matchbox


This product was added to our catalog on Saturday 18 February, 2012.

Your IP Address is: 54.90.92.204
Copyright © 2017 ToyResto.com. Powered by ZiaCart